Hello Stampin' Friends. Are you ready for a 3-D project? I made this sample Favor Box which would be perfect a table setting favor for a summer garden party or a tea party. And of course, all of the materials I used are Stampin' Up! products.
I began with the Artistically Inked dies and cut only half of the design. To took a photo of this (below) so that you could see how I did this. Simply, I cut 2.75-inch strips of white cardstock with my paper trimmer and cut those strips with the die, using less than half of the die area.
Next, I took a stylus and traced around my die cut image, noting where the flowers ended and the leaves and greenery began. Then using a Blending Brush and Polished Pink Ink, I lightly inked in my flower areas. Next, I used a dauber and the Soft Succulent Ink and inked in my leaves. Finally, I glued the die cut over the inked in areas.
I hand trimmed around the edge of the die cuts and applied them with glue to the front and back of the box.
The boxes are available in my online store, and they are SUPER-DUPER easy to assemble. The gold top of the box has a little loop of ribbon which is adhered inside the lid. I made a triple bow with the pink ribbon and a double bow with the lace. I laced the two bows into the loop on top of the box. I then went inside the lid and pulled one side of the ribbon loop tabs to tighten the loop. Finally, I tied a single twine bow around the ribbons. I finished the top with a little Thanks tag.
I am quite pleased with how these little boxes turned out. I finished each box with a band of Designer Series Paper around the bottom of the lid.
Below I will add links to my store for everything you will need to recreate this project! Thank you for stopping by today.
Product List
.jpeg)
No comments:
Post a Comment